StealthMiner Assembly Guide
I have more work to do for guides, but here is a quick timeplapse video... https://x.com/SatStackingPleb/status/1779632379528720396
The below table outlines the parts that I am using to assemble.
|
Hashboard |
|
|
Data Cable 18 pin (from hashboard) |
|
|
APW3++ |
|
|
Control Board |
|
|
Loki Lite |
|
|
Fan Noise Speed RPM Reduction Resistor Cable, 2Pin |
|
|
1/4''-20 X 4-1/2'' Phillips Oval Head Machine Screw, (25 Pack), 18-8 (304) Commercial Grade Corrosion Resistant Steel |
|
|
FN-GALE-01 * Each Gale fan comes with 2 sets of screws (8 total) and metal grill. The extra screws are used to secure the rear I/O plate |
https://www.digikey.com/en/products/detail/gelid-solutions-llc/FN-GALE-01/16714418 |
|
Battery Cables USA 6 AWG 20" w/ 3/16 inch (#10 stud)(M5) |
https://www.batterycablesusa.com/6-gauge-awg-marine-grade-battery-cable-with-ends |
|
13mm Black Hole Plugs Silicone Rubber Plugs for Round Holes |
|
|
6ft (1.8m) Heavy Duty Power Cord, NEMA 5-15P to C13 AC Power Cord, 15A 125V, 14AWG |
